halo for lining

[Pinhas]

i have a halo 4mm and i´m not to happy using for lining.
i try different set up but still no good
what set up do you use ?

[serial1313]

Try it at 9 volts with 1.5 to 2 turns out. Let me know how that works out for you. How were you running it & what did you not like about it's performance?

[ATS]

I use the same as serial give wise, but up to around 9.5v...

[Pinhas]

set up today at 9.5v and 2 turns out and work fine. i will tattoo for a few day to ajust my hand and see if a like it. i am used to tattoo whit a RW no give and its a bit different
now a have oder problem, the ink is spraying out off the tip any ideas why is doing that ?

[ATS]

Do you put a slight bend in the needle bar?
I do, just below half way down.. also, I very slightly bend the needles towards the back of the tip.
Hope this helps.

[vodu]

9 to 9.5 and 1 to 2 turns do the magic, i close a little when i line with round shaders...


Sent from my iPad using Tapatalk HD

[Pinhas]

i bend de bar a bit. the strange thing is that today a was tattooing with the halo but when a put the ink on the tip starts to spray so a change from the halo to Rw and din´t spray. the set up was the same

[vodu]

Stop bending the bar, try to bend the bar-needle junction



Sent from my iPad using Tapatalk HD

[fkirons]

i bend de bar a bit. the strange thing is that today a was tattooing with the halo but when a put the ink on the tip starts to spray so a change from the halo to Rw and din´t spray. the set up was the same

This could be due to the fact that the bar had more bend than needle creating a gap between where the needle glides in the tip causing it to spray. Bend the need stack instead and do not over do the rubber band tension as this will cause the needle to lift and give your undesired results.


Sent from my iPad using Tapatalk HD

[Pinhas]

bend just a bit the needle today and work perfect. solid machine for lining

[Pinhas]

thanks for the help :)