Nexz zero

[brandonmull]

If anyone else has ran these , i have a question . On the website it calls
this the quiet machine. This thing is damn near as loud as my weedeater.
i went to start a tattoo And it was soo loud it freaked the customer out
to the point i switched machines to calm her down. Even as loud
as a sidewinder is, its almost silent compared to the zero. Input?

[slicksteel]

Maybe Ed waldron (on here-owner)can sort it for you-maybe somethings wrong with it. The originals were a bit loud but not as loud as a coil.

[brandonmull]

well, then, ed? got any areas as to why the noise level is high?

[brandonmull]

i do mean ideas, not areas! oops

[slicksteel]

Nedz is using swiss maxon now in that model maybe you can send it in and he will swap that 6v chainsaw speed motor out for you and check for problems as well as give you the full spring set that was to come with it.

[reigningink]

I have one. And yeah, mine was loud too. I had a few red springs from my mr01 laying around, and swapped out the included spring out, then set the stroke to 3.5ish mm. And it quieted down to about the same as the non adjustable version. But neither is a quiet machine, I have never actually owned a quiet nedz. But when set up right they run on very low volts, I run mine at 3v or so. Any higher and it starts to get loud again. Hope you can get it lined out. They are excellent liners.