Swashdrive and Eikon, please advise!!

[Alec_Benjamin]

So I have been worrying myself silly about my gen 7 drawing amps far too high...
The read out on my EMS400 displays amps in the format 0.00, and when loaded with a 9 mag at 10volts the gen 7 draws about 0.07 amps.

Now the instructions with the swash say it should not run above 0.2...not 0.02, so what I'm asking is, is my swash actually running at below 0.1 amps? 0.1 amps being displayed as 0.10 on my EMS400?

Sounds very confusing I know, but seems to make sense in my feeble mind.

Tah all!

[Alec_Benjamin]

O.K I am retarded, and I don't blame anyone for not replying to this. My Gen7 is running below 0.1, which is brilliant haha. Here's me thinking that 0.07 is equal to 0.7.

[slicksteel]

you seemed to have solve it!

[Alie K]

You care way more than I do! I just plug them in and go. Amps, Schmamps! lol (Though my rotaries DO seem to run better on a power supply with a 'better' amp output)