EGO V2 Motor

[R0st0ck]

My Motor is broken...anyone knows where to buy a new motor for my machine? :confused:

[OwlsDen]

Contact Bez he sent me a new case for my v1 when the vice cracked. Otherwise it's a faulhaber 1717 or 1724 either one is available for about 50€ or less. I hear the drive beating is tricky to remove from the original. The motor number should be on the back of the one installed. There are some other threads about this too.

[Jack Steel]

it's a 172412SR if i'm not mistaken , but the driveshaft , is something different then that standard shaft

[No Iron Machines]

FAULHABER motor are good, but the torque are quite low

[Jack Steel]

so are the speeds (slow)

[R0st0ck]

Thanks guys....im also pretty sure,that its an Faulhaber 172412SR ,but the driveshaft is flat at that machine. Tried to contact Bez/Team EGO over FB and they told me,send an Mail to [email protected] .....No reply on my mail since 5 Days :(

[adamfromessex]

Dude, bare with bez's team. Had a v1 die, after a long time of use. a v2 vice crack, from me stepping on my cable. they sent me a new v2 for the v1, small service cost, and a new body shell for next to nought. And a few lil extras, phono to RCA adaptor :) very chuffed with the service but bare with it. It did take a couple of days on the first contact. But after that was very efficient


Sent from my iPhone using Tapatalk