Just Arrived. HM Rotaries to FK Irons

[fkirons]

HM rotary from Spain now available at www.fkirons.com
$420 for limited time.

Frame Crafted from a billet of 7075 Aircraft Aluminum.
Powered by a 6W Maxon Motor. Plenty of power for lining, color packing and smooth shades at lower voltage.
3.5mm Stroke. 4 Oz
Optional built in RCA (add$35)

If you don't see them on the site yet (need to take decent photos) hit me up over message or my email.
They are flying out.

$420 for limited time. Buy now at www.fkirons.com
33773378337933803381

[fkirons]

More images
338233833384

[strick9]

Awwe,fookin sweet Gaston!

[oake]

such a clean design.

[The Limey]

There's a nice pink one in there that I bet the boss would like to get her hands on! Didn't fancy any of the rhinestone ones eh Gaston?

[merky]

ill wait for machine,not feeling this hybrid spring stuff.

[gangstajay]

I have been wanting to see one of these machine run..can you do a lil video clip of it hooked up and running.. if its not to much trouble

[inked]

Sweet~ and good price too

[Tommy]

no disrespect intended, but I will personally never buy a machine with that kind of vise.

[Cyberitual]

Reminds me of the machine jcarlson is building.

[peter clements]

Reminds me of the machine jcarlson is building.

Joshua's machine will be better,and a better price.

[fkirons]

Machine runs really smooth and is the only machine I ever dare to carry on the site. Warranty wil be dealt here in the states, the price is pretty good. The machine construction is really solid.
The rubber band snapping problem was solved. Now the shaft comes rounded so they rubber bands stay on.
A few of them left.

[gangstajay]

hey fk how do they run as far as speed?? what would you relate the motor and stroke too, since you have used most rotary's out there

[slicksteel]

nice looking machines!

[fkirons]

hey fk how do they run as far as speed?? what would you relate the motor and stroke too, since you have used most rotary's out there

as far as speed, I don't know exactly the rpm but around 6-7volts depending what I want to do.
The stroke is about 3.5mm if I do a black and grey piece i hide the needle where what I get off the tube is about 1-1.5mm.
For lining I crank up the speed and hang about 2mm out.

Hope that answer your question.

[JCarlton]

I really like the look of these, I might pick one up if they are still available.