Franco....help....

[JayFatInk]

Where do i send my bishop,seems there is a short in the clipcord connection board or something...Franco can you help me or someone please...

[wildboy]

open the back plate and see if theres a loose cable and solder it...

[JayFatInk]

Opened it up...and it looks good..

[wildboy]

Its not working at all? I know that seems like a stupid question and maybe you have read the thread about the polarity already but have you tried to connect your clipcord the other way around?

[Administrator]

The polarity may be an issue since there is a diode in the board. If that does not work then call 949-916-1054. Whoever answers the phone should be able to help you.

[Gabetexas]

Its the same problem I was having.
Bishop Rotary Tattoo Machines
22622 Lambert Street
Suite 306
Lake Forest, Ca 92630
Phone (949) 916-1054 (tel:%28949%29%20916-1054)

[fkirons]

make sure your power supply is on...
Just messing with ya :D

[JayFatInk]

thanks everyone..the motor runs when you touch the clip cord to it,just seems there is a short in the board where the diode is...wierd..

[Gabetexas]

The same thing happened to me, Franco called, i sent it back, and had it back in a week.
Send it out to them.
It seems that the backplate had some issues.

[Administrator]

Could be a bad or blown diode. It happens, did you try calling. They should be able to fix it for you pretty quick. Sooner you get it to them the sooner you get it back ;)

[JayFatInk]

sending it out first thing in the a.m.....thanks everyone for the info...