PDA

View Full Version : direct drive rotory works, WH irons



G.Graves
01-19-2012, 11:14 PM
Alot of people that have the dd RW, have been bumbed it is to long. It is possible to fix this, i have done my machine and my buddy's.
after doing this, it fits the tubes perfect. 69176918





Then i changed up the WH irons alittle, I had two and sold one. I like the way these machines looked allot! I was hoping for it to perform better, and was about to sell it but then wanted to try to change it up a bit. Very happy with the way it runs and I will post up videos of it running before and after.

69196920

OwlsDen
01-20-2012, 05:10 AM
Very cool, I may have to cut my dd RW down too. How much did you chop off?

G.Graves
01-20-2012, 01:00 PM
I took off about an inch, I will check it to be exact. Then I smoothed out the edges so it feels better on the hand:) I the cut groves into them so it hold with out the little pin.

gangstajay
01-20-2012, 03:47 PM
i like the mod to the work horse.

G.Graves
01-20-2012, 07:29 PM
i like the mod to the work horse.

Thanks, it is very quiet now and consistent. I have another idea for it, but as it is right now I could put it back to the way it was if I wanted.

MedusaTattoo
01-23-2012, 05:16 PM
i just got a WH and the noise is one negative i will try also to make some changes, i will post them when is ready

linsner666
01-23-2012, 05:47 PM
:p here u go .... http://www.rotarytattoo.com/showthread.php/1055-The-Workhorse-Irons-Rotary/page5