PDA

View Full Version : bishop-line work



gangstajay
03-01-2012, 08:34 PM
So I got the new motor from franco and different bearings.. and I had a 3.5 installed and decided to use it for letting I did today.. I wasnt able to get a picture but I was very impressed with the outcome..I ran it at 10v and used a 7L. next time I use it I will post a pic. thanks for reading

Jim
03-02-2012, 04:11 AM
Nice to hear you got things sorted with the machine.

gangstajay
03-02-2012, 12:50 PM
yes the new motor has lots of torque I could have probably ran it at 9.5 ..I will put it to work today.

OwlsDen
03-02-2012, 12:57 PM
Might even be able to go down to 9 or 9.5. From what I understand the new motor is like the Maxon in the swiss. I was running a loose 7 at like 9 volts on the Swiss and it was slamming the line in. Those Maxon motors have so much torque.

gangstajay
03-02-2012, 03:15 PM
correction it is a maxon motor.

gangstajay
03-02-2012, 03:19 PM
shit I have my top draw all good to go... HM euro and the evolution,neo tats(both models),RW(brass & alum),franken Jay,the Lammy spec., dan kubin mini cranker which I think Iam going to get part with not sure yet it depends on what I can trade for it.