Barrett Russell
09-21-2012, 07:49 PM
Was researching rotary spec/photos upon embarking on making some, and I came across the board. Started tattooing in 2000, worked a street shop for a bit then at home while I was taking my bfa. Gave it up in 2005 as painting became priority, and as of last summer i began again, and have been lucky enough to be taken on by a local shop. I have acquired a machine shop by way of bicycle frame building. I am very in to metal work, and have built a few coil machines as far as making the screws, cores, phenolic washers from sheet, etc...I picked up a neotat a few months ago, and a lot of co-workers are using stigmas. So i am focusing on building some rotary machines now. Glad to be here.