Stigma FLY slows down ?

[devans]

Just a little problem im having with my stigma fly. It slows down like ive droped the volts to about 7 and then picks back up again ? I run it on an Ekon clip cord and a Micky Sharpz power supply (I have 2 and tried both) and usualy 7 to 15 curved mags. Cuz the motor can turn around on the back I wonder if ive ran it with the clip cord the wrong way round ? would this damage the motor ?. Any advice would be very welcome for a rotary newb :(

Regards,
Dallas.

[hellraiser6662]

Sounds like the motors finished my g7 started to do that and I'm trying to replace the motor. They go in the end some just dont work and some slows down

Sent from my LT26i using Tapatalk 2

[devans]

OH T%T SH%T :( ............ anyone got a FLY motor for sale :( .......... pleas ? .

[vodu]

The site of stigma, they have... Look for spare parts

Sent by the Devil using a vessel, one galaxy S2 and tapatalk 2

[Richard Peel]

Yeah Hit Stigma direct, sent them my Hyper a few months back due to it running funny and they sorted it and had it back in well under 2 weeks. off the top of my head motors were around 69Euros which you could probably fit yourself to

[OwlsDen]

Can always be a bad RCA cable too. I have had that same issue ( with another machine ) replaced the cable and the problem was gone.

[carlosbarraza]

I have one and I would say break it down and re-grease it and check the bearing at the cam to before sending it back.

thanks carlos