View Full Version : Rewired my clipcord modded Rapier today.
OwlsDen
11-12-2012, 02:56 PM
I bought this a while ago and always had trouble with it. I finally got the back off ( it had been super glued ) and found done rats nest of bad wiring. But I rewired it, and replaced the crap clipcord lugs with some brass ones I had in a drawer. I also added a brass colored RCA plug that I had a few extras from another project. And now I can't be happier. She is pretty again. Maybe I will get a new slide and make her like brand new next.
14514
You done a great job of that mate....
Eturnus
11-12-2012, 04:27 PM
Nice!
OwlsDen
11-12-2012, 04:48 PM
Thanks guys here is another glamor shot.
14524
Eturnus
11-12-2012, 10:46 PM
That ass..mmm
OwlsDen
11-13-2012, 11:48 AM
I wired up my Rotary Works Knuckleduster today as well. A while ago the clipcord base came off. I assume it had been attached too tightly as the solder lug had been cut in half by the grub screw. So I rigged it for a while and went about life. Recently I got tired of the not wonderful looking RCA conversion that I had done. So here is a slightly improved conversion.
14531
Powered by vBulletin® Version 4.1.12 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.