PDA

View Full Version : Grips for the MR03


Nedz
02-22-2013, 08:22 AM
17095

Here are the grips for the MR03.

Sizes are 28mm, 25mm and 22mm.
Wonderland
02-22-2013, 09:13 AM
Prices?
Nedz
02-22-2013, 10:19 AM
The machine will be £299 and the grips will be £75
Shawn
02-22-2013, 12:22 PM
The Mr03 will push hawk carts?
Nedz
02-22-2013, 04:01 PM
Yes the the MR03 is designed to work with Hawk and T-Tech tips.
johndameart
02-22-2013, 04:24 PM
When will they be available on the market?
MickWrath
02-22-2013, 05:06 PM
Adjustable needle float by twisting the grip like the stylus? What kind of motor is going in these guys? Watts? Operating voltage etc. Mick!
Nedz
02-23-2013, 08:43 AM
I am using some German motors at the moment on MR01 they are 7volt motors and run at either 21,000 rpm or 15,000 rpm depending on which model is required for lining or shading. These figures are of course for the motors running when not under load at 8.4 volts.
No Iron Machines
02-23-2013, 10:22 AM
u use FAULHABER MOTOR ???
Nedz
02-23-2013, 11:49 AM
Normally I use mabuchi or faulhaber but I am trying something different as well.