how to adjust give on blunderbuss2

[tattoo4satan]

hello everyone,
I just got a blunderbuss2 in the mail. Anyone know how i adjust the give? i tried messing with the top screw on the slide and im not sure if it acctually did anything. i read something about springs but i didnt get any. do i have to buy extra springs or something?

[tattoo4satan]

Cary gave me my answer, so i no longer neede advice.

[OwlsDen]

Cary gave me my answer, so i no longer neede advice.

Maybe it would be nice to share the info here to help others

[reigningink]

Hey there. The give adjustment is changed by tightening or loosening the large hex nut on top of the slide. It kind of camoflagges itself, it seems like it is just a hole , but its actually a threaded screw that compresses the give spring. The small hex nut (which can be seen through the large nut) is actually there to hold the armature in place. So don't loosen it or you will be able to pull the armature pin out of the slide. Again ,it is the very large hex nut on the top of the slide. I believe its a 5 or 6mm Allen wrench to fit it.