Diablo Kami motor jam

[sinister72]

Got a new Diablo the other day was working fine for a few hours then the drive shaft would stick when i went to run it i would have to give it a shift with my finger and it ran but every time i stopped to restart it would stick i thought it may be the ttec needle bar making it jam so i switched to normal tip and needle same problem today running a liner once its in motion its fine but it is annoying when it jams you can hear the motor trying to turn but drive bar sticks i was thinking of giving it some lube but being brand new it shouldn't need any grease just yet any suggestions

[slicksteel]

It should be under warranty still-get a new one. Are you can go on the dragonfly website and look at the diagrams they have-(same internal design)could be the return spring, a bearing sticking ,some internal parts messed up etc.

[sinister72]

Cheers mate will check it out

[(Opted Out)]

Usually when it does that the cam is not level with the slider motion i had it on a stealth and a rotaryworks, have a play or. Get a new one! :)

[sinister72]

yeah i might just send it back i couldn't be bothered tinkering with it cheers guys

[Stripe]

When I got mine it wasn't aligned well. I took it apart, oiled it up properly and put it back together as strait as I could. Ran like a champ after that...

[sinister72]

Thanks for response guys I decided to send it back Diablo are happy to exchange it plus they are going to send me one in red wich I ordered but got a black one so that's a bonus been using the flite V2 lately any how I love this machine

[Jack Steel]

don't forget who owns 'diablo rotary' ;)

[tattood]

who ?

[skinmech]

"The Devil"..In more ways than one...LOL

[Jack Steel]

@skinmech , how right you are sir :)
i'm not dropping any bombs of :p