Swash Gen7

Printable View

11-25-2011, 05:53 PM
mattelstone

Swash Gen7

this may or may not be a problem.. but i've been noticing lately that my gen7 machine has to "warm up" so to speak at the beginning of a session. meaning i have to set my power supply at say 9.5, and it sounds like the machine starts off slowly, and then starts getting faster and faster until it hits a consistent hum at what 9.5 should sound like.

has anyone else noticed this? is it even a problem? should i be keeping an eye out for another rotary for replacement? just curious.. i'm very new to rotaries.
11-25-2011, 10:00 PM
carlosbarraza

I too have had the same problem email [email protected]
11-26-2011, 04:37 PM
mattelstone

this email address didn't work...
11-26-2011, 04:37 PM
mattelstone

i even tried [email protected] , and it was returned back undeliverable.
11-27-2011, 02:01 AM
Administrator

[email protected] this is the email I have used... double check the spelling of the above posted email. ;) And let samyo know about the thread on the forum too. They like to be on top of stuff on here so others with the same problems can just read the answer. :)
11-27-2011, 04:31 PM
carlosbarraza

[email protected]

hehe it was missing a letter cut and paste fail.

this email was valid as the 25th of october.

thanks carlos
10-17-2013, 12:45 AM
RickNosky

So what was the reason for this problem? did they give any??
10-17-2013, 01:20 AM
carlosbarraza

i ended up replacing the main bearing with a ceramic one and it cured the problem. it was not hard to do and was about 20 bucks
10-17-2013, 03:20 AM
throwhammers

Quote:

Originally Posted by carlosbarraza

i ended up replacing the main bearing with a ceramic one and it cured the problem. it was not hard to do and was about 20 bucks

what bearing did you use? Where did you get it?
10-21-2013, 05:32 PM
carlosbarraza

It was from vxb.com and here is the info from my reciept

(6801-2RS Ceramic Bearing Si3N4 ABEC-5 12x21x5 Ball Bearings)

it was easy