direct drive rotory works, WH irons

Alot of people that have the dd RW, have been bumbed it is to long. It is possible to fix this, i have done my machine and my buddy's.
after doing this, it fits the tubes perfect. Attachment 6917Attachment 6918





Then i changed up the WH irons alittle, I had two and sold one. I like the way these machines looked allot! I was hoping for it to perform better, and was about to sell it but then wanted to try to change it up a bit. Very happy with the way it runs and I will post up videos of it running before and after.

Attachment 6919Attachment 6920

Very cool, I may have to cut my dd RW down too. How much did you chop off?

I took off about an inch, I will check it to be exact. Then I smoothed out the edges so it feels better on the hand:) I the cut groves into them so it hold with out the little pin.

i like the mod to the work horse.

Quote:

---

Originally Posted by gangstajay

i like the mod to the work horse.

---

Thanks, it is very quiet now and consistent. I have another idea for it, but as it is right now I could put it back to the way it was if I wanted.

i just got a WH and the noise is one negative i will try also to make some changes, i will post them when is ready

:p here u go .... http://www.rotarytattoo.com/showthre...s-Rotary/page5