New Direct Drive

It has my 3 stroke length system as well as German motor rated at 10,000 rpms.Attachment 14422Lightweight and very compact and super quiet, and there is no wobble at the needle end. This would be ideal for the Ttech system has loads of torque. It's only 3/4 of an inch thick by 2" tall. The distance from the tube vise is the same as a coil machine with 1.25" coils. Weighs 3 ounces with the weight shifted forwad for a good balance in the hand. Standard rubber bands work just fine on this machine. Powder coated frames in any color. Cost is $300.00 plus shipping.

Is it available in clip cord?

sent from my oobnoxiosly large galaxy note phone thing via tapatalk.

Sure I can do clip cord any way you want it.

Very clean simple looking machine. I bet it performs just as good as it looks

love that clean one piece look-easy to cheap clean

It has a wide power range for smooth grey or that peppered look, not to mention it's fast enough you can do lines as fast as you can move. With the 3 built in stroke lengths you can set it up any way you like.

What kind of set up is that for connecting the needle bar?

Dang...why did ya have to go and put up a red one.....:cool:

It is a flanged bearing, you open the eyelet of you needle bar just a little and snap it over the bearing. No shredded grommets as there is no grommet. Not to mention less friction and more power to the tip of the needle.

Super quiet to.