Machineoshitto

Vinoshitto, Pm if your needing my address :)

Cant wait to try it out!

Looks sweet!!!

I like the idea of the silicone bar,it looks very promising..i like to give it a try.

Did these three.. updated with a clear silicone tube to prevent the arm from moving backwards due to the o-ring pulling force... or what to call it. you know what I mean.


Gonna ship two of them out today for a trial run..

Attachment 17681Attachment 17682l

Yeah nice solid looking Drive mechanism and motor housing.....The only "very" small issue I see at present is the Vice Clamp....Are you going to leave it as it is with the square edge pressing against the front of the tube, or is the edge being rounded..Square edges tend to crush disposables, and unless really tightened down a ss tube can slip and slide....Apart from that all looks cool..:)

yes, the clamp is not shaped as it will be later on.
the whole machine is water cut right now. hence the gnarlyness..

Easier, faster and cheaper that way until I find the right measurements and what not.. Then I can cut them out in CNC to get it more proper.


John Dame and Serial1313.. test machines are in the post right now.

Give them a go and hit me back!
Thanks!

/Oskar

Thank you sir, I will.

Thanks buddy Ill let you know what I think!

I got my machine today. It's very quiet & looks like it will have the give of a coil machine w/ the rubber on the armature bar. I had to tighten the screw that attaches the vise to the frame, so it might could use some Loctight on that screw. So far that is all the critique I have because I haven't used it yet.