Hand cut brass DD with clipcord connection
Not a review, just felt like sharing a recent build I mine. I have been building a few DD machines lately and have mostly been doing clipcord connectors as well. I have gone through 4 or 5 RCA cables in the past few years yet have had the same clipcord for 9 years. I am starting to switch back. I have built this all by hand, with the exception of drilling holes. Where needed parts get silver soldered or wired with silver bearing solder. I used a solid brass wire ( insulated with clear heat shrink ) rather than a conventional wire for better durability. The spindle was custom made for me. The motor is Mabuchi an this thing is punchy at 4 volts. I intend to start putting it through the paces tomorrow.
http://img.tapatalk.com/d/14/02/05/yma8epun.jpg
http://instagram.com/p/kATDjjKgeC/
For a better view. Tapatalk seems to limit the image sizes pretty awful these days.
http://img.tapatalk.com/d/14/02/05/uzyte4uz.jpg
http://img.tapatalk.com/d/14/02/05/e8upe5am.jpg
