Right here goes I've done mine so I'm just showing you how to undo The hawk other machines might be different #1 undo The rear cover anti-clockwise, under that are 3 0.9 Allenkey grub screws remove them very important. #2 pull the connection out unsolder it from the two wires, make note of the + as it needs to goto the centre of the rca, #3 now undo The main body anti-clockwise it will unscrew all the way off, now you can see a circuit board contected to the back of the motor, I've done away with that but it's your choice if you do, you can now solder some longer wire if you don't think it the old wires will reach for you to solder a rca to it. #4 screw the body back together with the wires poking out the back, solder your rca on and use little shrink rap, push the rca in the hole, it won't go right in because of the case, then put the 3 allen key grub screws back in. You can centralise the rca with the 3 allen grubs fit the end cover and it's done.

Sent from my LT26i using Tapatalk