i love the look of these!

[slicksteel]

Were here ya go it-seems rollhard wants to slander me as posted on my inkjecta classified post.http://www.rotarytattoo.com/showthre...fic#post101969 received a E. Lollis in a trade with him. This design is made to use a front tensioner needle guide (df copy)as it has a reverse motor. First of the front end was off, the guide sets right on the tube (even if you use a shot one) this causes the guide to not be usable. The reason the screw becomes tight(to the point of forcing it and possibly breaking it) is because there is no room for the guide to go forward. ence you can not use it to put proper tension against the needlebar. Rollhard admitted in a phone message that he could not use the guide and use a rubber band -which he admits did not even line up right due to the side mount rca. Another issue this machine had was the vice put uneven pressure against the tube which made it not line up right. this was to due to the vice hole being a slight oval & oversized and the bottom of the needle guide pushing against the tube. Also this machine needed a kickstart sometimes to as it would be come stuck on the down stroke as the needlebar would not properly center up due to the front end problems and the rocker arm distance not centering the needle in the tube. Also if you put a rubber band around the machine which would go around the back motor connect bar it will also make this stall/start up problem worse. So in fact this machine has major problems . Rollhard stated that I could trade it back if I did not like it. But when I did want to trade it back due to these issues he became angry because he could not pawn it off on another person and started problems on here for me. If this machine did not suit my style I would have simply kept it and traded it to another person. But I will not accept a poorly built machine that has major problems that the trader new & did not disclose before hand. I would not trade this machine or sell it for that matter to another tattooist to pass on these problems. And I will not lie and tell everybody that this machine is great when it is not just so Rollhard can dump it on another person that is scared to speak up for fear of being bashed etc when they get it. In my opinion this machine should never had been sold to the first guy-it should have be sent out as a free use prototype to find out the bugs in this machine style and correct them. So mister rollhard to satisfy you, because you are such a stand up guy I simply "did not like it" and what I stated to you and on here is just my "opinion". So feel free to trade/sell this machine to you hearts content if that makes you happy as most likely no one really cares what I have to say anyways. Peace