DarkLab RPG Disposable is almost here!

[fkirons]

I just ordered a Timothy Boor Fk shader and an al 13 proton liner and I was wondering if I hâve to make anything to make it work withe the Fk Rpg and hawk needles. If anyone can answer me about this it would be very nice. Thanks.

In fact, Timothy Boor uses his machine with carts very often.

If your machine was setup as a color packer (Untouched factory setup), you can run most cartridges with no problem.
One thing to avoid is using rubber band and if you have to use only one.
Dab about 1.5 cm in ointment or PTFE grease from time to time.

With Any coil machines, we've noticed that machines performed best when the throw is not longer than 3mm with an unloaded duty of 47-50.

Aluminum RPGs can be autoclaved and cold sterilized.


Any other question feel free to email us at [email protected] or call 855-FK Irons and we'll be happy to help.

when are these going up for preorder? ill be placing a fairly big order. haha

We are hopping to have them ready for sale in 30-45 days.
We are held up by the printing of boxes and custom injected silicone grommet that we are including with each grip.
We made some adjustment to the resting shoulder of the grommet) so the needle bar + grommet can be reversed loaded without the need of removing grommet from bar hoop.

[AltarVinz]

Thanks à lot for the answer Gaston. Machine is said to be set up as a soft shader ( for the Juan Salgado ( just been noticed Timothy's were solded out and)) and the proton is set up as a liner. I ordered them from a UK store as I live in Europe. Hope I'll be able to run them with carts !

[fkirons]

Thanks à lot for the answer Gaston. Machine is said to be set up as a soft shader ( for the Juan Salgado ( just been noticed Timothy's were solded out and)) and the proton is set up as a liner. I ordered them from a UK store as I live in Europe. Hope I'll be able to run them with carts !

You will just tweak the rear compression and don't over do your throw.

[AltarVinz]

Working perfectly ! Thanks Gaston !