Some New DIRECT DRIVE from XXX IRONS

**No Iron Machines** · 10-07-2014, 03:04 PM

HELLO GUYS, here some of the New DIRECT DRIVE i build recently for my Hand made productions, front part is IRON the Motor Plug with Aluminium, create a very well balanced machine on front, different colors available

Forum Member i sale 200 USD with Worldwide Shipping inlcude by Register Air Mail

u can see here all the machines:
https://www.facebook.com/pages/XXX-I...=photos_stream

SPECIFIC:
-Pre-fab 2 pieces laser cut frame parts from 1018 Low Carbon Iron and screwed together with Aluminium Motor Plug with contacts
-Frame is polish on tumbler, sandblast and spray paint with MONTANA and MOLOTOW BELTON bomb to prevent rust
-Reverse guillotine tube vise, work fine with Steel and Disposable tubes
-Brass hardware
-3.5 stroke, perfect for everything
-Silent high torque motor with special motif wrapped around and protect with vinyl film
-Normal Clip cord and RCA connection built in
-The machine push easy Needles Cartridge from Cheyenne and T-Tech, starting at 7 volts
-Easy rubber band back connection
-Recommended voltage use from 8-12 V , 90-140 HZ speed
-125 grams weight
-1 YEAR Full Warranty on all parts and motor

WARNING: FOR MOTOR SAFETY ALWAYS RUN ON ANTI-CLOCKWISE AND NEVER RUN THE MACHINE LOWER THAN 6 VOLTS AND HIGHER THAN 12 VOLTS