I will say that the over all engineering is nice quality, and the machine runs very nice. I was almost able to line as fast with it as with the same groupings in a coil. The ability to change the angle of the mag groups without affecting the balance of the machine also speeds things up (shading off of left hand lines being a righty feels and looks much smoother).

I ordered expecting a little trouble, but something IMO that is this stupid was unexpected. Friction based attachment does work, but in this instance it is not the appropriate form of attachment. After a little more thought last night I believe they wanted to avoid a balancing issue caused by putting a set screw in the offset shaft. If that is the case, I mark it in my book as plain lazy. If they just didn't think about it, plain ignorant. I just have a hard time accepting that they made such a huge mistake.