Results 1 to 7 of 7

Thread: EGO V2 Motor

  1. #1
    Member R0st0ck's Avatar
    Join Date
    Oct 2012
    Location
    Selb
    Posts
    48
    Post Thanks / Like

    EGO V2 Motor

    My Motor is broken...anyone knows where to buy a new motor for my machine?
    Sorry for my bad english,i am to old to learn it anymore perfekt....I think

  2. #2
    Knows Whats Up! OwlsDen's Avatar
    Join Date
    May 2011
    Location
    Nürnberg
    Posts
    3,647
    Post Thanks / Like
    Contact Bez he sent me a new case for my v1 when the vice cracked. Otherwise it's a faulhaber 1717 or 1724 either one is available for about 50€ or less. I hear the drive beating is tricky to remove from the original. The motor number should be on the back of the one installed. There are some other threads about this too.

  3. #3
    Machine Builder I build Tattoo Machines Jack Steel's Avatar
    Join Date
    Mar 2012
    Location
    Diamond City
    Posts
    260
    Post Thanks / Like
    it's a 172412SR if i'm not mistaken , but the driveshaft , is something different then that standard shaft

  4. #4
    Machine Builder I build Tattoo Machines No Iron Machines's Avatar
    Join Date
    Nov 2011
    Location
    ITALY
    Posts
    570
    Post Thanks / Like
    FAULHABER motor are good, but the torque are quite low

  5. #5
    Machine Builder I build Tattoo Machines Jack Steel's Avatar
    Join Date
    Mar 2012
    Location
    Diamond City
    Posts
    260
    Post Thanks / Like
    so are the speeds (slow)

  6. #6
    Member R0st0ck's Avatar
    Join Date
    Oct 2012
    Location
    Selb
    Posts
    48
    Post Thanks / Like
    Thanks guys....im also pretty sure,that its an Faulhaber 172412SR ,but the driveshaft is flat at that machine. Tried to contact Bez/Team EGO over FB and they told me,send an Mail to [email protected] .....No reply on my mail since 5 Days
    Sorry for my bad english,i am to old to learn it anymore perfekt....I think

  7. #7
    Senior Member
    Join Date
    Nov 2011
    Location
    Essex
    Posts
    219
    Post Thanks / Like
    Dude, bare with bez's team. Had a v1 die, after a long time of use. a v2 vice crack, from me stepping on my cable. they sent me a new v2 for the v1, small service cost, and a new body shell for next to nought. And a few lil extras, phono to RCA adaptor very chuffed with the service but bare with it. It did take a couple of days on the first contact. But after that was very efficient


    Sent from my iPhone using Tapatalk

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •