Page 2 of 2 FirstFirst 12
Results 11 to 14 of 14
  1. #11
    Senior Member eduki's Avatar
    Join Date
    May 2014
    Location
    Bilbao Spain
    Posts
    239
    Post Thanks / Like
    I never ran mine higher than 8.5,it vibrates but I don't consider them noisy.

  2. #12
    Senior Member
    Join Date
    May 2012
    Location
    East Lansing
    Posts
    147
    Post Thanks / Like
    SoundS like you need to send it back, I. Sure do would sort it out pronto

  3. #13
    Member
    Join Date
    Mar 2011
    Location
    Niagara Falls
    Posts
    90
    Post Thanks / Like
    It all boiled down to user error and the power supply, Thanks for the input everyone

  4. #14
    Member
    Join Date
    May 2014
    Location
    yarm
    Posts
    37
    Post Thanks / Like
    I have 3 Halo's and none of them ever spit ink... Put a small bend about an inch back from the point where the needles are soldered to the bar, I don't bother with more than 2 turns of give, sometimes the but that slides that the n eels ha attaches to is very stir so give doesn't work, strip it down and careful wet and dry sand until they slide smoothly and easily. Also find that 9.0v works for just about anything, just change the stroke wheels and give really.

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •