-
Knows Whats Up!
Jack steel mk3 eats rubber bands
I got a jack steel machine in a trade and I love it. It lines like a beast and it is so light. My only problem I am having is when using regular rubber bands is they sit again the set screws holding the motor in and the threads rip the bands.
I tried a halo rubber band straight to the screws as I had seen other people do and it does it even faster.
I am talking like a band gets broken in less than 20 seconds.
How is everyone else attaching rubber bands so they don't get chewed up.
Sent from my iPhone using Tapatalk
-
Knows Whats Up!
Have you checked the set screws for burrs? A rough thread could eat a rubber band pretty quick. I've had mine for about four months now and haven't lost a band yet.
-
Machine Builder
Hi ,
i'm glad to read that u like the machine!
there is a lot of time and love in each machine i produce ,
that being said i would love to help you out
i've had this issue in the past here and there , but most of the times it was because of the bands being old or the bands are getting chewed by the needle going in the tube with the band on it (don't know if this makes sense)
try setting your stroke all the way down , then adjust your grip to your liking , and tighten , then the band only goes up and back down , and no longer in the tube
hope this helps
if not shoot me a message on facebook or
[email protected]
peace
Jack
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks