I se the same 2 machines as my go to drivers. I use carts, i use the o ring that came with the direkt on the push bar, and a small runner band on my h&m dd. Altho i drilled a few .060" holes and
Fit a couple push bar ends in as a "custom" band holder.helps to keep it them a bit more quiet.

QUOTE=ecsd;128705]Here is a simple band holder, a #56 iirc drill bit, and a couple push bar ends.
The bit i used was .001" smaller than the drive bar OD (.060) after that, its pretty self explanatory




[/QUOTE]


.