Quote Originally Posted by Jesse Phillips View Post
How are you setting it up for lining? I haven't had a lot of luck lining with mine.
I am not certain what I have the stroke length set to exactly but when the machine is running there is a dime size gap in between the (figure 8) when you look at the armature bar if that makes sense? I run the machine slow, a little over 9 volts and I go through and basically sketch the lines in, like I am shading almost, to commit the stencil and then go back over and sketch over them again to darken them up to where they need to be. I have found that adjusting the stroke on the fly to be extremely freaking useful because if I feel it is hitting too hard I shorten the stroke a tad or when shading I start in a non critical area and do some light shades to see how the dot spacing is and adjust the stroke till she is nice and smooth. These things are crazy versatile and am pretty excited to give the Cobra 2 a go.