Evolution Rotary- smartened up.

[spoonertattoos]

thanks I thought of that but wasnt sure if the screw was wide enough. now I see it is. I just ned to get my hands on a dremmel. thanks! Ill post once I get my whole thing modded with RCA etc.

[peter clements]

thanks I thought of that but wasnt sure if the screw was wide enough. now I see it is. I just ned to get my hands on a dremmel. thanks! Ill post once I get my whole thing modded with RCA etc.

That's right ,the Dremmel,but use a thin disk to cut down to the hole thus forming the slot and then very carefully grind away at the inside of the slot till it just allows a needllebar to slide through. A good way to start the cut first is to use a thin flat needle file on edge,go down about 1 mm and then gently away with the dremmel. This little machine is easy to mod up,it'll look nice with an RCA-post pictures when you've sorted it.