Chinese Hawk Copy !

[Tat2nu]

I can tell you that I spec out the materials used, pin diameter, pin taper, grouping configurations and soldering characteristics and if at any time the product does not fall within my specs I do not have to pay for it and it is replaced as soon as possible by my factory. The exact manner in which I accomplish this is somewhat proprietary but I can tell you that I pay more because I demand more. That is also why I sell for more than some of the volume/profit based suppliers.

[Amoebadesigns]

It's a sad truth but most everything these days is made in China. Even most of Eikons products are produced there as well. If you look on their needle boxes it says in plain English "made in China". I get a good chuckle from some of the Chinese suppliers and how they like to copy machines. On the fake Eikon website I found 4 of my machines in their machine lists that have been copied from me. I see them all the time on Chinese suppliers sites and Ebay. It's not like I make anything basic like some builders do...I make everything one of a kind and sculpted different so it's very easy for me to see the copies of my machines. To date I have found 7 different machine copies from my original machines and I'm sure there are way more than that. The strange thing is they were machines I made around 7 years ago that were on my website back then. I've attached the "copies" they did from my originals.
copy1.jpgcopy2.jpgcopy3.jpgcopy4.jpg

[slicksteel]

I think they wait for awhile because they figure you made your money of it,forgot about it and will not do anything about it. If built those and seen them for sell on ebay i would have them pulled.