Stigma Hyper v2

[JohnnyChaos]

careful with the screw. there is a little ball bearing underneath so if the screw comes out you might lose that and then be unable to tighten it up fully.

[geddy]

I was weirded out by the armature pin at first as well just tighten the screw and no worries. I haven't put my hyper down since I got it three months ago.

[crowman]

Im getting a lot of needle bounce with it recently needs 4 bands to keep it steady over 10 volts.......one thing that gets me....the "give" screw supposed to be wound out for a softer hit and vice versa for harder.....i find it the opposite

[Assassin Rich]

I have the hyper and a dragonfly..I was a hawk user but switched.. I love the hyper for lining . It is the best liner for me. I just dont know where to oil these things.. I dont wanna mess em up.. I wrote stigma but no reply yet .. But amazing machines.

[GuruJeph]

I have the hyper and a dragonfly..I was a hawk user but switched.. I love the hyper for lining . It is the best liner for me. I just dont know where to oil these things.. I dont wanna mess em up.. I wrote stigma but no reply yet .. But amazing machines.

says to shoot a little superlube on both sides of the moving armature housing every 30-50hrs of use

superlube.jpgimg005.jpg

[crowman]

im taking mine back to the supplies shop i bought it from on monday.......9.8 volts and its rattling around in the tip....thats with a mighty 1/4 inch band on there really tight....i like the machine for mag work but cant handle the needle lifting to the front of the tip everytime i switch machines running higher volts

[Assassin Rich]

Thanks guru

[TattoosByRob]

For the hyper V2 you can add the lube where the white nylon set screws on either side of the pin assembly, for me anyway I undo the nylon screws add a small squirt of lube screw them back in.....They should be screwed in only enough to stabilize the the pin assembly, I usually have them loose then run the machine and slowly tighten em until it runs smooth and stable...........Hope this helps

[crowman]

Just swapped it....the new one runs smoother and doesnt bounce......but the top screw rattles loose and needs its own elastic band....ho fkn ho

[elbo]

Stigma!...run great for 3 to 6 months(if you are lucky)...hopefully there will be a hyper v3 that will last for a year?