Results 1 to 2 of 2
  1. #1
    Senior Member
    Join Date
    Jun 2011
    Location
    Camborne
    Posts
    366
    Post Thanks / Like

    Gen 6 Heating up

    My gen 6 seems to get very hot at the top of the motor housing after only about 10min even when I run it at 7volts. It isn't making excessive noise as in worn bearings and isn't pulling more than 0.02 amps. I have changed the clip for a new one and done up the screws on either side so they are just tight. Tried it on different power supplies all to no avail, any ideas of what else I can try?

  2. #2
    Machine Builder I build Tattoo Machines jesoner79's Avatar
    Join Date
    Feb 2012
    Location
    marietta georgia
    Posts
    707
    Post Thanks / Like
    im having a similar situation with my bishop and my gen6 and a neo tat

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •