Results 1 to 10 of 10

Thread: Swash Gen7

  1. #1
    Member
    Join Date
    Jun 2011
    Location
    Rehoboth Beach
    Posts
    35
    Post Thanks / Like

    Swash Gen7

    this may or may not be a problem.. but i've been noticing lately that my gen7 machine has to "warm up" so to speak at the beginning of a session. meaning i have to set my power supply at say 9.5, and it sounds like the machine starts off slowly, and then starts getting faster and faster until it hits a consistent hum at what 9.5 should sound like.

    has anyone else noticed this? is it even a problem? should i be keeping an eye out for another rotary for replacement? just curious.. i'm very new to rotaries.

  2. #2
    Member carlosbarraza's Avatar
    Join Date
    Feb 2011
    Location
    dixon ca
    Posts
    63
    Post Thanks / Like
    I too have had the same problem email [email protected]

  3. #3
    Member
    Join Date
    Jun 2011
    Location
    Rehoboth Beach
    Posts
    35
    Post Thanks / Like
    this email address didn't work...

  4. #4
    Member
    Join Date
    Jun 2011
    Location
    Rehoboth Beach
    Posts
    35
    Post Thanks / Like
    i even tried [email protected] , and it was returned back undeliverable.

  5. #5
    Site Technical Admin The Sheriff Administrator's Avatar
    Join Date
    Aug 2010
    Location
    Toronto
    Posts
    3,282
    Post Thanks / Like
    [email protected] this is the email I have used... double check the spelling of the above posted email. And let samyo know about the thread on the forum too. They like to be on top of stuff on here so others with the same problems can just read the answer.

  6. #6
    Member carlosbarraza's Avatar
    Join Date
    Feb 2011
    Location
    dixon ca
    Posts
    63
    Post Thanks / Like
    [email protected]


    hehe it was missing a letter cut and paste fail.

    this email was valid as the 25th of october.

    thanks carlos

  7. #7
    Junior Member
    Join Date
    May 2011
    Location
    Geelong, Melbourne
    Posts
    4
    Post Thanks / Like
    So what was the reason for this problem? did they give any??

  8. #8
    Member carlosbarraza's Avatar
    Join Date
    Feb 2011
    Location
    dixon ca
    Posts
    63
    Post Thanks / Like
    i ended up replacing the main bearing with a ceramic one and it cured the problem. it was not hard to do and was about 20 bucks

  9. #9
    Senior Member
    Join Date
    Aug 2011
    Location
    Switzerland
    Posts
    372
    Post Thanks / Like
    Quote Originally Posted by carlosbarraza View Post
    i ended up replacing the main bearing with a ceramic one and it cured the problem. it was not hard to do and was about 20 bucks
    what bearing did you use? Where did you get it?

  10. #10
    Member carlosbarraza's Avatar
    Join Date
    Feb 2011
    Location
    dixon ca
    Posts
    63
    Post Thanks / Like
    It was from vxb.com and here is the info from my reciept

    (6801-2RS Ceramic Bearing Si3N4 ABEC-5 12x21x5 Ball Bearings)

    it was easy

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •