I do permanent makeup - hello!

[wildboy]

It might be the RCA...it just sort of fades out and stops. If I let it sit for a week or so it will run again for awhile.

Waverly...I'll check it out, thx.

What power supply do you have? Sounds like the power supply could cause the problem. I worked with a knock off Critical power supply and had the same problem with my Bishop after a couple of month but the machine runs fine on an original Eikon EMS400...

[The Limey]

Welcome to the forum! If you don't like Waverly, Silerback 11 heals black not a blue/grey like most sumis.

Shoot Ray (The man behind Neotat) a PM about your machine issues if you can't resolve your problems.

[slicksteel]

dynamic black is very dark and stays black can be used for line and shade and the price is great!

http://skincandytattoosupply.com/categories.php?category=Dynamic
You could have a short in the cord wire (only a few wires touching inside the sheath that will heat up and cause this some times)
also a faulty solder job in the rca /pug ends can cause this-try some one elses cords then there powersupply.

[Sekt]

Welcome to the forum =]
Be good to hear more experiences from cosmetics peeps, they seem a quiet bunch !

[Administrator]

It might be the RCA...it just sort of fades out and stops. If I let it sit for a week or so it will run again for awhile.

Waverly...I'll check it out, thx.

Odd, best to call the workshop. Karen of Ray will be able to help you. I know they are at the SPCP show this weekend but will probably be back monday or tuesday. I have seen the cutting out issue from a bad minijack cord in the past.

Anyway Number is 928.473.4185

[Magnu]

Hello and welcome to the forum

[Gabetexas]

Very cool! Welcome Aboard!

[eyeliner]

The new cable worked for the Neo BTW. I'm stoked because I really do like that little machine. It's not an RCA connex though, it's like the cable you use on your iPod. 1/8 inch I guess? Anyway thank you for the tip.