stigma

**skarnsink** · 03-23-2012, 02:32 PM

Hey guys, iv'e have my stigma hyper for a week now and love it but it is a bit noisy compared to my other rotarys , is this normal ? just the swash baering i thought ? any info would be great .
thanks .
SkarnsInk

**Baldrick** · 03-23-2012, 03:55 PM

Is it a hyper or a hyper v2 - because the v2 , with the plastic side screws in the top, is a lot quieter than the older version.

**elbo** · 03-23-2012, 04:18 PM

or yours is on its way out!!!!

**Baldrick** · 03-23-2012, 04:23 PM

Originally Posted by elbo

or yours is on its way out!!!!

Yeah that's a possibility if it is the v2

How old is it and has it ever been dropped, or serviced?

**skarnsink** · 03-23-2012, 05:38 PM

just bought it brand new and yeah hyper 2 with the plastic screw on the side guess i should ring the supplyer on monday ? so they are quiet say , comaired to rotary works?

**Baldrick** · 03-23-2012, 05:58 PM

There quiet normally, compared to a rotary works - yeah similar level I would say. ( been awhile since I had a RW)

**Magnu** · 03-23-2012, 06:06 PM

Hyper V2 normally runs with little noise.I have 3 Have you tried lubricating the sides of the platic slider where the rod that takes the grommet is? There should be lubricant and instructions if the machine was new and boxed

**skarnsink** · 03-23-2012, 06:08 PM

ok , well i guess its a little loalder than the RW but not to much, just not silent like the swiss knock off i have , think i'll send the supplyer an email about it and they have a stand at the Helsinki convention next weekend so i'll go see them with the machine ..

**skarnsink** · 03-23-2012, 06:10 PM

Originally Posted by Magnu

Hyper V2 normally runs with little noise.I have 3 Have you tried lubricating the sides of the platic slider where the rod that takes the grommet is? There should be lubricant and instructions if the machine was new and boxed

well it looked like there was lube there but i just ran it straight out of the box thinking it would be fine