hawk machine is dead

[hellraiser6662]

Very bad bearing sound so bad when it squeals the whole machine slows down what motors does it uses and ig possible to replace? Or throw it in the bin haha

[Sage Oz]

Could just be a bad bearing, try disassembling it and running the motor free of the drivetrain to see if it is shot or if it's running then the prob is in the drive

[Sage Oz]

Once it's disassembled, take measurements of the motor (length X diameter X shaft size) to find a replacement or upgrade....

[Administrator]

Very bad bearing sound so bad when it squeals the whole machine slows down what motors does it uses and ig possible to replace? Or throw it in the bin haha

Have you tried contacting HAWK?

[hellraiser6662]

DSC_0125.jpgDSC_0125.jpg
This is 2 hawks insides one is my old 2 year old model with a dead maxon re-max 326770 motor but on there site the numbers dont match anything? The other motor works I just thought I would take it to bits to match the motor but alas it just black with no numbers? Anyone knows what I can replace the broken motor with? Machine builders?

[hellraiser6662]

DSC_0126.jpg

[Administrator]

Hawk may have a propriety motor made for them swiss or not.

sent from my oobnoxiosly large galaxy note phone thing via tapatalk.

[hellraiser6662]

there is some circurt board on the back any builders know why? or can i just replace the motor with any thing?

[OwlsDen]

That is a voltage regulator and polarity fault board. If you replace it with a motor of the same size you will not need the board, but it may run better with it. If you reuse the board make sure to match the polarity on the motor, otherwise it will not work at all.