Spektra Halo feedback thread

[PAWNJOB]

I've tried T-Techs w/ a couple different rotaries and found that they worked well, except that the pre-loaded cartridges put a noticeable amount of extra strain on the motors which I didn't like. The cartridges also take too much off the hit in my opinion, especially when lining. You usually run at higher volts than you do w/o them too. As a result of increased load and higher volts I've noticed my machines heating up a bit so I stopped using them for the most part. I still use my Storm w/ them cause I don't mind much if it takes a shit, already sent one back for a painless exchange. Then I read this:

I'm using T-Tech cartridges with the Halo's front spring removed and pushes them no worries, the give screw is so responsive a slight turn and you feeeeeeel the change.

Brilliant Myst!

Gaston, is this a viable option? While removing the Halo's front spring would probably compensate for the pre-loaded cartridges, would this set up degrade the Halo's give system in any way or can the Halo still perform properly w/o it? I gotta say that if this system works well it would be ideal. Unless you can already say that this is not a good option Gaston, could you please give this a try when you get a chance. I think the builder's opinion would give us a better perspective.

Thanks for that post Myst.