rca hawk no crap cable any more

[hellraiser6662]

DSC_0277.jpg
This is a rca hawk, I broke a motor not so long ago so I pulled it apart learnt how it goes together as its all held with very little allen key grub screws but as you unscrew the two halfs you will rip out the wires, why? Thats because the power male is held in by 3 grub screws at the back there is a number on the cover unscrew that and there they are undo them and it wont rip the wires out when you pull it apart. All I did was replace the male plug to a rca all good.

[asA]

hahah i like the hawk cable.. its lasted longer than any rca cable ever has.

[hellraiser6662]

Oh I hate it. Its far to long and it slows the hawk down by one volt. Ive tested it against a short converted cable and the normal out of the box and its looses one volt. Plus you have to tape the hawk one inplace as ive found it gets loose after a while and ive had one brake.

[Shawn]

Did the same thing to a rotar