Page 3 of 3 FirstFirst 123
Results 21 to 21 of 21
  1. 07-10-2012, 02:10 PM #21
    Sage Oz
    Sage Oz is offline
    Knows Whats Up! Sage Oz's Avatar
    Join Date
    Oct 2011
    Location
    Bellevue, Washington.
    Posts
    2,724
    Post Thanks / Like
    Quote Originally Posted by aldrizzle View Post
    what mods did you do on the workhorse?
    Switched it to RCA only, replaced the large flat drive bar retaining screw with an equal stainless one(quiets it down), added a spring to the pivot shaft that put a bit of horizontal tension on the pivot and eliminates side motion(it now has linear motion with no added resistance), and added a needle tensioner. oh, and added a bearing on the drive arm.


    Sent from a galaxy far, far away...
    Last edited by Sage Oz; 07-25-2012 at 06:26 PM.
    Reply With Quote Reply With Quote
« This a custom build for Nicks Rotarys | Current lineup... »

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules