polarities!!?

[sleezy23]

I just got a stigma hyper 3, and it says it polarity protected? i re soldered my clipcord and now it works, and my other rotaries still work too, but is it hazardous to the other motors to switch it up like that?

[vodu]

nope. at least i never heard of

[Sage Oz]

It can shorten the life of an electrical motor reversing the direction of spin

[rollhard]

my stigma will only run when the clip cord is correctly set. are the newer ones not set up this way? also why did u have to solder your clip cord ?

F

[vodu]

but this isn´t for brushed motors Sage?

[sleezy23]

I use the RCA jack

[serial1313]

You should buy a RCA cord. They have some nice ones for just under $10 from Eikon. Then you can use the RCA for all of your rotary machines.

[sleezy23]

yes, i had to resolder the rca clipcord.

[serial1313]

I think that is where the confusion is coming from. When you said clipcord in the beginning & now again, everybody is thinking a power cord w/ clips on the end(a clipcord) not a power cord w/ a RCA jack on the end. I can't imagine that it would give your other rotaries any problems now that you have re-soldered it.

[vodu]

Lol...wasn't a clipcord?

Enviado de meu GT-I9100 usando o Tapatalk 2