Different strokes for different fokes. MR03 Design Question

[PAWNJOB]

Sent from my Nexus 7 using Tapatalk 2

[johndameart]

3.5-3.8, i usually stay at that as well. and I'm a little confused as well pawn lol

[S_Trofatter]

if someone cant tell the differance between a 3.5 and a 5 mill stroke then they dont know how to tattoo yet.

[Bishopbyname]

I know i'd know the difference between a 3.5mm and 5mm stroke machine. I have an adjustable direct drive machine and at it's longest stroke (5mm) i find it very difficult to tattoo with smoothly but when i adjust it to around 3.5mm stroke i find it tattoos much better. I can see how someone wouldn't be able to tell the difference between a 3.2mm and say 3.8mm stroke with just the naked eye and feel. But a 1.5mm difference is a lot.

[The Limey]

3.5 for me, it does everything and has enough punch for Rhino skin

[Nedz]

Thanks for the input I am going to make it 3.8mm or there abouts.

[e_Bangs]

Can i get a 1 mm stroke with a 3 curve mag long taper!

[MickWrath]

3.8 would be so nice because you have the 3.5 abilities plus that little bit extra for lining. I'm super excited about the MR03

[PAWNJOB]

The length of the stroke might ultimately be dictated by the machine, the same stroke length on a different machine sometimes has a different feel. I think somewhere upward of of 3.5 would be ideal for an all-arounder though, and 3.8 sounds like an excellent starting point! Looking forward to the machine.

P.S. The Pussy Juice got me and my client through my single longest session ever - 11 hrs! About 10:25 hrs of actual tatooing. He only needed it for the last couple few hrs but it really got him through. Thanks again!

Sent from my SCH-S720C using Tapatalk 2

[PAWNJOB]

So the MR03 is Released, what's the stroke length!???