Need help with my Prodigy

[crabink]

Why don't you shoot Stigma an email and ask how it compares to the Hyper V3 as they list all the Hz info for that.

i did lol

[crabink]

I think the confusion between watts and volts is causing this..crab repeatedly said its 4.5 volts. But it's really a 12volt motor .. So he's just running it to slow.
I bet a lot of people get those two mixed up... Am I right?

yes.. lol i did

[MickWrath]

I run mine around 9 with ttechs so you should be good between 7-9 volts depending on your hand speed. As mentioned you should start with the give knob turned in all the way for no give an back it out slowly until you find your spot. Let us know how it goes after a couple pieces.

[crabink]

got a piece today.. final session of a half sleeve pheonix encircled by blue flames.. gonna give it a toss. thanks mick

[MickWrath]

Let us know how she runs for ya.

[crabink]

well fucking well... The Prodigy performed fucking bomb... I went through an entire saturation and blending session on sick phoenix half sleeve I been working on in 2 and half hours with the Prodigy running around 7 - 7.5 with a 9 bugpin mag.. about one turn out for give.. I will say this... i completely had the idea of give all wrong... its not coil machine give lol.... its tattooing fast as fuck and here's a little dampening for ya give. It is more like a DD even with the give opened a little... so that was a good learning experience. That being said, thanks for the help.. i think I will keep it... or trade it for a Halo lmfao