MR03 shipped this week.

[Nedz]

You mean the main body of the MR05 the piece the motor fits to yes its £125

[Denner]

I am talking about this part:

mr05-slow.jpg

[Nedz]

£25 each plus shipping

[asA]

Are you going to change the fitment of the cartridges into the grip? Or are you happy with how they are now? I mean mine dont even twist in.... you just kinda use all your strength to jam them in to a point and then to get them out when they are a little slippery is near impossible. Its nothing like the fit in the stylus or the cheyenne grip. It seems like the opening needs to be way bigger.

[stevencash1]

Yes I agree about the fit of the cartridges one of the grips I got with my set up the cartridges won't even go in at all the other two I have you have to jam them in as well. Did anyone else get any grips that you can't fit the cartridges in at all?

[artoftatt2]

I broke three t tech cartridges off in my grips today..and my m03 runs so erratically notated what I do.. Also the straight needle bars don't work well with the grips for the m05 they miss the head of the t tech needles pushrods half the time.. I'm really feeling none of these products were well thought out or tested for several months before release..

[stevencash1]

I haven't gotten my mr05 stuff yet but did you get to do a tattoo with it? Or is it just not working right at all?

[tatu richie]

damn seems to me this is bad... dig ur other machines but what happened here man? did u put it to a test? i have read several here hving the same issue... not good

[artoftatt2]

Well I've tried to tattoo with both of them they work and then they don't .. The hole in the grip is too small to use a plunger like the t techs come with so when you try and use a normal needle bar it will slip of the drive part of the t tech.. And the drive system for the m03 will act erratic because the cam is not secured to the drive bar so that play makes it hit a ill different each time.. All things that should have been thought out...

[stevencash1]

Ya I've done a few tattoos with the mr03 it did pretty well but I just didn't like the way it ran it wasn't very smooth I was hoping that these new parts were gonna fix things that were wrong with it and make it run smoother I can only wait to get my parts to see how it works I'm hoping my stuff works or at least fixes the problems