Results 1 to 10 of 14

Threaded View

  1. 10-21-2013, 10:01 AM #14
    tattood
    tattood is offline
    Knows Whats Up! tattood's Avatar
    Join Date
    Jan 2013
    Location
    Rohnert Park, CA
    Posts
    784
    Post Thanks / Like
    Quote Originally Posted by zack_fa1r View Post
    matt my 4.2 is loud aswell, franco said to me the bearing may be rubbing against the side wall inside the frame!!! but mine originaly was a 3.5 so he says thats why, you just gota run the machine while tightening the bottom screws and move the motor around a little bit until you find its quietest.
    this is exactly what i had to do to mine. My advice send it in and have Franco try his best to remedy the noise. It is a real pain having to adjust the motor till it gets just right. And to be honest, this never really made the machine that much more quiet. Also the noise is from a sloppy slide. run the machined and put a lil pressure on the slide and it will quiet it way down. I had some luck with a tight rubber band going all the way around and through the needle clip. Hope that helps ~
    Last edited by tattood; 10-21-2013 at 12:15 PM.
    Reply With Quote Reply With Quote
« cheyenne needles poping out of the cart | Swash Gen7 »

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules