I took a cord with a 1/4 male on one end plugged into my power supply and the other end was just 2 exposed wires..I touched one wire to the tip of the plug and the other end touched the plug closer to the base (about half way down..you may have to move the wire around a bit to get to the right spot on the shaft) and then I stepped on the footswitch..the machine started right up..
Unimax gave me a hard time about it but when I e-mailed the manufacturer I spoke with konrad lackner. he never asked me when I bought the machine or where I got it from. he said if I was to send it to germany I would need the paperwork for customs reasons. but then he wrote back and said just send it to unimax and didn't ask for any paperwork or anything. (the machine was bought from painful pleasures) He just said unimax was the closest distributor to me and to contact them and send them the machine and they would replace the entire unit with a new one. I waited all day for unimax to return my call (they never did) so i called them back and the guy said he got my e-mail but if I sent them the machine they would just send it to germany and the shipping would cost alot. I said,"so, because it would cost alot to ship it to germany thats why you ignored my e-mail and didn't return my phone call" I then told him I talke with konrad and he said to send it to them and they would replace it..he responded "ok, if thats what he said, send it to us and we'll replace it."...I mailed it to them today and since they are only about 60 miles from me, they should get it by tomorrow..we'll what happens from there...
Bookmarks