DarkLab RPG Disposable is almost here!

[artoftatt2]

It's all techniques and their is a dozen ways to skin a cat.. Of coils work for you then use em.. Don't try anything new and don't change anything .. All that matters is how you feel and your clients feel about your work.. Not what you use or what bandwagon you jump on.. Their is a lot of guys who enjoy cartridges and only use on machine for all their needs.. Others prefer multiple machines set up different ways.. What rotaries have you tried? I've used and owned easily over 30 so I might have some insight for you.. Currently I enjoy in no peticular order is my dan Kubin sidewinder , my gen 8s and my spectra directs.. I use cartridge for certain things and stick to regular needles and tubes for others.. I still use a few ciferri coils and a few other coils from time to time too

[needlemaniak]

Hey Gaston, they look sweet ! Will they work with the flex bars of the flite v2 (vice version) ?


Sent from my iPhone using Tapatalk

[fkirons]

Hey Gaston, they look sweet ! Will they work with the flex bars of the flite v2 (vice version) ?


Sent from my iPhone using Tapatalk

Not yet but we may offer a bar to work with.


Sent from my iPhone using Tapatalk

[fkirons_kayleigh]

So what bout if you have 3 coil machines. Liner shader packer. Surely you cant stil use one machine.

Sent from my GT-I9505 using Tapatalk

While the RPG grips may not eliminate the need for multiple coil machines with different set ups, it will allow you to use multiple different needle groupings with 1 machine (for example if you want to use both a smaller and larger liner grouping or several different mag sizes on your shader) so that you would need to set up fewer machines for the same tattoo than using conventional needles

[needlemaniak]

Thanks Gaston !


Sent from my iPhone using Tapatalk

[fkirons]

There are some videos up on our Instagram @fkirons, in case you to check them out.




Sent from my iPhone using Tapatalk

[jasonadelinia]

Iv got 3 properly tuned coil machines. So will I hav to use all 3 machined still with cartridges. Sorry only reason is past year iv tried alot of rotaries. But coils still top it for me. They just slap the ink in with out effort. Rotaries just bounce of the skin too much as the push ink in the skin instead of wip it in like a coil. Just my personal preference.

Sent from my GT-I9505 using Tapatalk

I believe there is a thread somewhere with rough digits on how to tune a coil for cartridges. I've set my FK exactor up to push cartridges and It lines amazing for large groupings and packs and whip shades great. You basically have to compensate for the rubber band in the cartridge. Thicker back spring too.

[johndameart]

when are these going up for preorder? ill be placing a fairly big order. haha

[AltarVinz]

I just ordered a Timothy Boor Fk shader and an al 13 proton liner and I was wondering if I hâve to make anything to make it work withe the Fk Rpg and hawk needles. If anyone can answer me about this it would be very nice. Thanks.

[slicksteel]

tell them you want it sprung for carts-the setup is different