any ideas ?
a couple of weeks ago i put some light oil on the bearing not realizing its self lubricating.
i noticed a few days later that when holding the machne 'normally' it would loose power and increasing voltage wouldnt adjust the power to a point where it cut out at 12.5v (protective circuit)
if i held the machine upside down it suddenly picks up power and operates normally.
i stripped the machine and noted oil had migrated down to the back of the motor and onto the PCB. i dried it as best as i could, used a hairdryer on it too, rebuilt and tested - same thing !
i stripped it again only to break the fekking wires off the PCB to the jack !!!
a mate who is an electrical engineer took the machine to his lab where he re-attached the wires, not before removing the PCB from the motor and noting oil was on the back of the board, he dried it and rebuilt.
when i got it back it worked great for 2 days, now im seeing the same power limited issue ???? again it picks up fine upside down...
i really love this machine and im gutted that im getting this issue, any help/suggestions would be appreciated
Julian