Sidewinder V6 and cartridges

[Noa]

I'm not mechanically inclined. I just got the v6 as well. Would love to understand visually : "looped a #10 rubber band around the vice and up over the armature bar to cancel out the cartridge tension" ? Thank you, Noa

[Butternuts]

I'm not mechanically inclined. I just got the v6 as well. Would love to understand visually : "looped a #10 rubber band around the vice and up over the armature bar to cancel out the cartridge tension" ? Thank you, Noa

I've since traded the V6 for the new Centri but I can explain how to do it. As far as difference in lining from V6 to other rotaries, the V6 is designed for and accomplishes what it is designed for which is easily pushing larger rounds so if you're a traditional guy and use lots of big liners for bold line work and have a fast hand then the Kubin would be an asset to your collection. As it came tuned from Dan it was a bit too fast and hard for my liking so I backed off the impact screw and was able to find a setting that I liked. I hated the clipcord though. I made a clipcord to RCA piece but it was pretty wonky using it. I'm sure I could have hard wired an RCA connection to it but doing so you would loose the option of reversing the polarity which makes the machine run different. As far as looping the rubber band goes, the idea is to cancel out the upward tension caused by the spring or membrane in the cartridge so get a rubber band and loop it however you want around the machine so it will pull down on the armature bar to cancel out the upward tension from the needle cartridge.