Bishop RCA back

[Hybridreload]

I have a newer bishop capo 4.2mm stroke. It's an RCA. I was thinking about getting into cartridges, but I have to remove the stay up spring. None of Franco's videos show how to take apart the newer generation models with an RCA. Any advice on how to remove the stay up spring?

[Patrick]

I believe there are two set screws at the bottom of the machine body. Remove them, slide the motor out, pull the slider out and remove the stay up spring from the bottom. Then reverse the process to re-assemble. It'll be a bit louder without the spring.

[nivek]

I believe there are two set screws at the bottom of the machine body. Remove them, slide the motor out, pull the slider out and remove the stay up spring from the bottom. Then reverse the process to re-assemble. It'll be a bit louder without the spring.

Yep This